User's Manual

Configuring System Parameters
BreezeACCESS Series 21 Base Station Equipment Installation Manual
3.2.1 Configuring Parameters Common to All Product Families
1. From the
main menu
, type
3
to access the
Basic Configuration
menu.
2. From the
Basic Configuration
menu, type
D
to access the
DHCP Client
menu. Type
1
to access the
DHCP Options
menu and select the required
option. If the option was selected to other than
Disable
, type
2
to access the
Access to DHCP
menu and select the required option. If the
DHCP Only
option was selected, go to step 6. Otherwise (if either the
Disable
or
Automatic
options were selected), perform steps 3-5.
3. Type
1
to access the
IP Address
selection screen. Enter the required IP
address.
4. Type
2
to access the
Subnet Mask
selection screen. Enter the required subnet
mask.
5. Type
3
to access the
Default Gateway Address
selection screen. Enter the
required default gateway address.
6. Type
4
to access the
ESSID
selection screen. Enter the required ESSID.
7. For BreezeACCESS II units, proceed to Section 3.2.2. For BreezeACCESS
XL units, proceed to Section 3.2.3. For BreezeACCESS MMDS units,
proceed to Section 3.2.4.
3.2.2 Configuring Parameters Specific to BreezeACCESS II
1. Type
7
to access the
Hopping Sequence
menu. Enter the required hopping
sequence.
2. Type
8
to access the
Hopping Set
selection screen. Enter the required
hopping set.
3. If more than one AU-BS is used, they should be synchronized for optimal
spectrum utilization. Type
6
to access the Hopping Sync selection screen.
Enter the required hopping sync status (Master or Slave).
Note:
Only one AU should be defined as a Master. The other units should be
defined as Slaves. If only one AU is used, it should be defined as Idle.