User's Manual

Configuring System Parameters
Base Station Equipment Installation Manual 20 BreezeACCESS Series
• Parameters specific to BreezeACCESS II Access Units:
⇒ Hopping Sequence
⇒ Hopping Set
⇒ Hopping Sync (if using more than one AU-BS)
• Parameters specific to BreezeACCESS XL Access Units:
⇒ Hopping Band
⇒ Frequency Offset
⇒ Flexible Hopping Definition
Note:
There are several ways to define the hopping frequencies using various
subsets of the above parameters. The parameters to be used depend on the
specific model as well as on specific system requirements, as determined by
the system administrator.
⇒ Hopping Shift (if using more than one AU-BS)
⇒ Hopping Sync (if using more than one AU-BS)
• Parameters specific to BreezeACCESS MMDS Access Units:
⇒ Flexible Hopping Definition
⇒ Hopping Shift (if using more than one AU-BS)
⇒ Hopping Sync (if using more than one AU-BS)
Note:
You must select Reset Unit in the Unit Control menu for the changes to take
effect.
See Appendix B for more details on the basic parameters.