User's Manual
Table Of Contents
- BreezeACCESS Version 4.3 System Manual Revision 3.0
- Contents
- Book 1: System Description
- Contents
- Chapter 1 - Introduction
- Chapter 2 - System Components
- Chapter 3 - Specifications
- System Specifications
- BreezeACCESS II Radio Regulatory Standards
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication
- (SU-A/E, AU-A/E-NI, AU-A/E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- Book 2: Installation
- Contents
- Chapter 1 - IF-Based Equipment
- Packing Lists
- SU-A/E Subscriber Unit
- Modular Base Station Equipment
- Standalone AU-A/ENI Access Unit
- Other Items Required for Installation
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- Chapter 2 - Indoor SU-R Units
- Chapter 3 - Indoor SU-I and AU-I Units
- Book 3: Commissioning
- Book 4: Operations and Administration
- Contents
- Chapter 1 - Accessing the Monitor Program
- Chapter 2 - Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Traffic Statistics (AU and SU)
- Voice Statistics (SU with Voice Support Only)
- Per Hop Statistics (AU and SU)
- Ping Test (AU, SU and GU)
- Continuous Link Quality Display (Available in SU Only)
- MAC Address Database (Available in AU Only)
- Per-rate Counters (AU and SU)
- RSSI Display Option (AU and SU)
- ATPC Counter (AU and SU)
- AU Alarms (IF-based AU Only)
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- RADIUS Parameters Menu (Subscriber Units only)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Appendices
- Appendix A - Configuration Download/Upload
- Appendix B: Software Version Loading Procedure
- Appendix C: Supported MIBs and Traps
- BreezeACCESS System Object Identifiers
- brzAccessMIB
- Service Parameters
- RADIUS General Parameters
- Accounting Parameters
- RADIUS Authentication Parameters
- User Filtering Parameters
- Network Management Parameters
- Bridge Parameters
- Air Interface Parameters
- Performance Parameters
- Site Survey Parameters
- Special Operations Parameters
- Unit Control Parameters
- IP Parameters
- System Information Parameters
- Alarms Parameters
- brzPhoneMIB (applicable to SU with voice only)
- Supported Traps
- Appendix D: RSSI to dBm Conversion Table
- Appendix E: Parameters List
- Appendix F: Hopping Sequences
- Index
C-22
BreezeACCESS Version 4.3 System Manual
Manual Revision: 3.0
Performance Parameters
*ScanningMode
710.3.3.6.35
(*AirInterface 35)
Applicable to SU only. Not applicable
if *ACSEOption is enabled. Sets the
scanning mode.
passive (1)
active (2)
na (255)
*SendRoamingSNAP
710.3.3.6.37
(*AirInterface 37)
Applicable to all SUs, except to SU-
BD and SU-BD1V. Disables/enables
the Send Roaming SNAP feature.
Integer
disable (0)
enable (1)
na (255)
*AUTransmissionRateContro
l710.3.3.6.38
(*AirInterface 38)
Applicable to SU only.
When enabled, the maximum rate of
transmissions from the AU to this SU
is determined by the value of the
Maximum Data Rate in the SU.
Integerdisable (0)
enable (1)
na (255)
*MacAddressBlackList
710.3.3.6.39
(*AirInterface 36)
Applicable to AU only. Not
Accessible. MAC Address Black List
parameters
* MacAddressBlackListTable
710.3.3.6.39.1
(*MacAddressBlackList 1)
Applicable to AU only. Not
Accessible. A list of up to 100 MAC
Addresses of SUs that will not be
served by the AU.
*MacAddressBlackListTableEntry
710.3.3.6.39.1.1
(*MacAddressBlackListTable 1)
Applicable to AU only. Not
Accessible. An entry in the Mac
Address Black List Table.
*MacAddressBlackListTableIdx
710.3.3.6.39.1.1.1
(*MacAAddressBlackListTableEntry 1)
Applicable to AU only. A read only
table index for a MAC Address entry
in the Mac Address Black List Table.
Integer
1-100
*MacAddressBlackListId
710.3.3.6.39.1.1.2
(*MacAddressBlackListTableEntry 2)
Applicable to AU only. The list of
MAC Addresses in the Mac Address
Black List Table. To Remove a MAC
Address - SET the corresponding
entry to 0. To Add a new MAC
Address - SET an entry which is
currently 0.
MacAddress
MIB Parameter
(Location in Parenthesis)
Description Values/Range
*PerformanceParams
710.3.3. 7
(brzAccessMib 7)
*NumOfRetransmissions
710.3.3. 7.1
(*PerformanceParams 1)
Applicable to SU and AU. Maximum times
to retransmit an unacknowledged packet.
Applicable only when the *ACSEOption is
disabled.
Integer
0-100
*NumOfDwellToRetransmit
710.3.3. 7.2
(*PerformanceParams 2)
Applicable to SU and AU. Minimum dwell
periods during which an unacknowledged
packet is retransmitted.
Integer
0-9
*NumOfRetransToDecRate
710.3.3. 7.3
(*PerformanceParams 3)
Applicable to SU and AU. Number of
unsuccessful retransmissions to decrease
the transmission rate.
Integer
0-10
*MinContentionWin
710.3.3. 7.5
(*PerformanceParams 5)
Applicable to SU and AU. Determines the
size of the contention window, which is the
time to wait before transmission for
collision avoidance.
Integer
7-255.
*MaxMulticastRate
710.3.3. 7.6
(*PerformanceParams 6)
Applicable to SU and AU. Maximum rate
for transmission of multicast and
broadcast messages.
Integer
max1Mbps (1)
max2Mbps (2)
max3Mbps (3)
na (255)
MIB Parameter
(Location in Parenthesis)
Description Values/Range