User's Manual
Table Of Contents
- BreezeACCESS Version 4.3 System Manual Revision 3.0
- Contents
- Book 1: System Description
- Contents
- Chapter 1 - Introduction
- Chapter 2 - System Components
- Chapter 3 - Specifications
- System Specifications
- BreezeACCESS II Radio Regulatory Standards
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication
- (SU-A/E, AU-A/E-NI, AU-A/E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- Book 2: Installation
- Contents
- Chapter 1 - IF-Based Equipment
- Packing Lists
- SU-A/E Subscriber Unit
- Modular Base Station Equipment
- Standalone AU-A/ENI Access Unit
- Other Items Required for Installation
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- Chapter 2 - Indoor SU-R Units
- Chapter 3 - Indoor SU-I and AU-I Units
- Book 3: Commissioning
- Book 4: Operations and Administration
- Contents
- Chapter 1 - Accessing the Monitor Program
- Chapter 2 - Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Traffic Statistics (AU and SU)
- Voice Statistics (SU with Voice Support Only)
- Per Hop Statistics (AU and SU)
- Ping Test (AU, SU and GU)
- Continuous Link Quality Display (Available in SU Only)
- MAC Address Database (Available in AU Only)
- Per-rate Counters (AU and SU)
- RSSI Display Option (AU and SU)
- ATPC Counter (AU and SU)
- AU Alarms (IF-based AU Only)
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- RADIUS Parameters Menu (Subscriber Units only)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Appendices
- Appendix A - Configuration Download/Upload
- Appendix B: Software Version Loading Procedure
- Appendix C: Supported MIBs and Traps
- BreezeACCESS System Object Identifiers
- brzAccessMIB
- Service Parameters
- RADIUS General Parameters
- Accounting Parameters
- RADIUS Authentication Parameters
- User Filtering Parameters
- Network Management Parameters
- Bridge Parameters
- Air Interface Parameters
- Performance Parameters
- Site Survey Parameters
- Special Operations Parameters
- Unit Control Parameters
- IP Parameters
- System Information Parameters
- Alarms Parameters
- brzPhoneMIB (applicable to SU with voice only)
- Supported Traps
- Appendix D: RSSI to dBm Conversion Table
- Appendix E: Parameters List
- Appendix F: Hopping Sequences
- Index
Appendix C
C-9
BreezeACCESS Version 4.3 System Manual
Bridge Parameters
MIB Parameter
(Location in Parenthesis)
Description Values/Range
*BridgeParameters
710.3.3. 5
(brzAccessMib.5)
Bridge parameters.
*EthBroadcastFiltering
710.3.3. 5.1
(*BridgeParameters 1)
Applicable to SU only.
Enables/disables the filtering of Ethernet
(layer2) broadcasts.
disable: No filtering.
ethOnly: Filter broadcasts received on the
Ethernet port only.
wlanOnly: Filter broadcasts received on the
Wlan port only.
bothWlanAndEth: Filter broadcasts received on
both ports.
Integer
disable (0)
ethOnly (1)
wlanOnly (2)
bothWlanAndEth(3)
na (255)
*VLANSupport
710.3.3. 5.2
(*BridgeParameters
2)
Applicable to AU, SU and GU. VLAN Support
Parameters.
*VlanID
710.3.3. 5.2.1
(*VLANSupport 1)
Applicable to SU only. VLAN ID for data frame
tagging. Applicable to Access Link only.
Integer
1-4094.
0 means not applicable
*EthernetLinkType
710.3.3. 5.2.2
(*VLANSupport 2)
Applicable to AU and SU. VLAN support mode
(Link Type).
The Access Link option is not available for AU.
Integer
accessLink (1)
trunkLink (2)
hybridLink (3)
*ManagementVID
710.3.3. 5.2.5
(*VLANSupport 5)
Applicable to AU, SU and GU. VLAN ID for
management frame tagging. For SUs with voice
support it is also used for tagging voice frames
(RTP packets).
Integer
1-4094
65535 means no VLAN
tagging.
*VoicePriorityTag
710.3.3. 5.2.6
(*VLANSupport 6)
Applicable to SU with voice only. Enables
prioritization tagging of voice (RTP) frames
according to IEEE 802.1p when
*ManagementVID is 65535 (No VLAN).
Integer
disable (0)
enable (1)
na (255)
*VLANForwarding
710.3.3. 5.2.7
(*VLANSupport 7)
VLAN Forwarding Feature Parameters
*VlanForwardingSupport
710.3.3. 5.2.7.1
(*VLANForwarding 1)
Applicable to AU and SU. Enables or disables
VLAN Forwarding. (applicable in Trunk links
only)
Integer
disable (0)
enable (1)
na (255)
*VlanForwardingTable
710.3.3. 5.2.7.2
(*VLANForwarding 2)
Applicable to AU and SU. A VLAN Forwarding
Table of up to 20 VLAN IDs of devices to which
data frames are forwarded when VLAN
Forwarding is Enabled. (applicable in Trunk
links only). Not accessible.
*VlanForwardingEntry
710.3.3. 5.2.7.2.1
(*VlanForwardingTable 1)
Applicable to AU and SU. A VLAN Forwarding
Table entry. (applicable in Trunk links only). Not
accessible.
*VlanForwardingIdx
710.3.3. 5.2.7.2.1.1
(*VlanForwardingEntry 1)
Applicable to AU and SU. A read only table
index for a VLAN entry in the VLAN Forwarding
Ta bl e .
Integer
1 - 20
*VlanIdForwarding
710.3.3. 5.2.7.2.1.2
(*VlanForwardingEntry 2)
Applicable to AU and SU. The list of VLAN ID's
in the VLAN ID Forwarding Table. To Remove a
VLAN ID - SET the corresponding entry to 0. To
Add a new VLAN ID SET an entry which is
currently 0.
Integer
1-4094
0=remove entry.
*VLANRelaying
710.3.3. 5.2.8
(*VLANSupport 8)
VLAN Relaying Feature Parameters
*VlanRelayingSupport
710.3.3. 5.2.8.1
(*VLANRelaying 1)
Applicable to AU only. Enables or disables
VLAN Relaying. (applicable in Trunk links only)
Integer
disable (0)
enable (1)
na (255)
*VlanRelayingTable
710.3.3. 5.2.8.2
(*VLANRelaying 2)
Applicable to AU only. A VLAN Relaying Table
of up to 20 VLAN IDs of devices to which data
frames are relayed when VLAN Relaying is
Enabled. (applicable in Trunk links only). Not
accessible.