User's Manual

Menus and Parameters
2-91
BreezeACCESS Version 4.3 System Manual
Upon enabling overlap sending, the settings of other dialing
parameters are overridden as follows:
a. IP Dialing Option, Dialing Prefix Option and Stop Dialing
Indicator are disabled even if the applicable parameter is set to
Enable.
b. Automatic Prefix is not used and Stop Dialing Timeout has
no effect.
The default selection is Disable.
Telephony Signals (Subscriber
Units with Voice Support Only)
The Telephony Signals menu defines the various call progress tones that
indicate the status of a telephone call, the ringer parameters and some
timeouts. The call progress tones are generated by the Subscriber Unit
in accordance with call progress information as received from the AU or
the telephony network.
The parameters in the Telephony Signals menu include the following
options:
 Telephony Country Standard – Selects the call progress tones
standard. The following options are available:
 Proprietary – Allows definition of specific tones (see below).
 Germany
 Sweden
 France
 United Kingdom
 Belgium
 USA
 Chile
The default selection is USA.
 Dial Tone –Defines the dial tone transmitted to the earphone to
indicate that the call can be supported by the system and that the
caller may start dialing.
 Ring-Back Tone – Defines the tone transmitted to the earphone to
indicate that the telephone of the called party is ringing.
 Busy Tone – Defines the tone transmitted to the earphone to
indicate that the telephone of the called party is busy.
 Congestion Tone - Defines the tone transmitted to the earphone to
indicate that the system cannot currently support the call (e.g. if a
line is not available since the AU currently supports the maximum
allowed number of voice sessions).