User's Manual

2-6
BreezeACCESS Version 4.3 Operations and Administration
Manual Revision: 3.0
includes some additional useful read-only information such as the
Number of Hopping Frequencies (SU and AU).
Unit Control Menu
The Unit Control menu includes the following options:
 Reset Unit – Resets the BreezeACCESS unit and applies any
changes made to the system parameters.
 Defaults Settings – Resets the unit to a predefined set of default
parameters or to save the current configuration as Operator
Defaults. The available options are:
 Set Defaults – Resets the unit to a set of default parameters.
The following options are available:
 Cancel Request – Exits to the Unit Control menu without
any change.
 Set Complete Factory Defaults – Available only with
Administrator access rights. Resets the unit to the set of
Alvarion’s standard default values. These are the default
values as defined in this manual for each of the parameters.
After the next reset all parameters will revert to their Factory
Defaults value, except for the parameters that are marked in
the “Complete” column of
Table 2-1‚ page 2-7
.
 Set Partial Factory Defaults – Reverts all parameters to the
values of the Factory Defaults configuration after the next
reset, except for parameters that are necessary to maintain
connectivity and to enable management of the unit and some
other sensitive parameters. The exact list of parameters that
are not changed depends on the access rights of the user.
Referring to
Table 2-1‚ page 2-7
, the parameters that are
not changed after activating Set Partial Factory
Defaults using Administrator access rights are marked
in the “Partial-Admin” Column. The parameters that are
not changed after activating Set Partial Factory
Defaults using Installer access rights are marked in the
“Partial-Installer” Column.
NOTE:
Activating Set Complete Factory Defaults will result in loss of connectivity.
If the unit is managed remotely, you may lose the ability to communicate
with it.