User's Manual
Table Of Contents
- BreezeACCESS Version 4.3 System Manual Revision 3.0
- Contents
- Book 1: System Description
- Contents
- Chapter 1 - Introduction
- Chapter 2 - System Components
- Chapter 3 - Specifications
- System Specifications
- BreezeACCESS II Radio Regulatory Standards
- Data Communication
- Voice/Fax (Subscriber Units with voice support)
- Telephony (Subscriber Units with voice support)
- IF Indoor – Outdoor Communication
- (SU-A/E, AU-A/E-NI, AU-A/E-BS)
- Configuration and Management
- GU-RA GPS Radio
- GU-RA to BS-GU Communication
- Environmental
- Standards Compliance, General
- Physical Specifications
- System Specifications
- Book 2: Installation
- Contents
- Chapter 1 - IF-Based Equipment
- Packing Lists
- SU-A/E Subscriber Unit
- Modular Base Station Equipment
- Standalone AU-A/ENI Access Unit
- Other Items Required for Installation
- Guidelines for Selection of Equipment Locations
- Installing the Outdoor Unit
- Installing the SU-NI and AU-NI Indoor Unit
- Installing Modular Base Station Equipment
- Installing the GU-A-BS GPS and Alarms System
- Chapter 2 - Indoor SU-R Units
- Chapter 3 - Indoor SU-I and AU-I Units
- Book 3: Commissioning
- Book 4: Operations and Administration
- Contents
- Chapter 1 - Accessing the Monitor Program
- Chapter 2 - Menus and Parameters
- Main Menu
- Info Screens Menu
- Unit Control Menu
- Basic Configuration Menu
- Site Survey Menu
- Traffic Statistics (AU and SU)
- Voice Statistics (SU with Voice Support Only)
- Per Hop Statistics (AU and SU)
- Ping Test (AU, SU and GU)
- Continuous Link Quality Display (Available in SU Only)
- MAC Address Database (Available in AU Only)
- Per-rate Counters (AU and SU)
- RSSI Display Option (AU and SU)
- ATPC Counter (AU and SU)
- AU Alarms (IF-based AU Only)
- Advanced Configuration Menu
- IP Parameters (AU, SU and GU)
- Air Interface Parameters (AU and SU)
- Network Management Parameters (AU, SU and GU)
- Bridge Parameters (AU, SU and GU)
- Performance Parameters (AU and SU)
- Service Parameters (AU and SU)
- RADIUS Parameters Menu (Subscriber Units only)
- Security Parameters (AU and SU)
- Voice Parameters (Subscriber Units with Voice Support Only)
- Dialing Parameters (Subscriber Units with Voice Support Only)
- Telephony Signals (Subscriber Units with Voice Support Only)
- Hopping Parameters (GU)
- Alarm Parameters (GU)
- Appendices
- Appendix A - Configuration Download/Upload
- Appendix B: Software Version Loading Procedure
- Appendix C: Supported MIBs and Traps
- BreezeACCESS System Object Identifiers
- brzAccessMIB
- Service Parameters
- RADIUS General Parameters
- Accounting Parameters
- RADIUS Authentication Parameters
- User Filtering Parameters
- Network Management Parameters
- Bridge Parameters
- Air Interface Parameters
- Performance Parameters
- Site Survey Parameters
- Special Operations Parameters
- Unit Control Parameters
- IP Parameters
- System Information Parameters
- Alarms Parameters
- brzPhoneMIB (applicable to SU with voice only)
- Supported Traps
- Appendix D: RSSI to dBm Conversion Table
- Appendix E: Parameters List
- Appendix F: Hopping Sequences
- Index
iv
BreezeACCESS 4.3 System Manual
System Manual Book 3:
Commissioning
Setting Basic Parameters ....................................... 1-1
Accessing the Monitor Program .............................................. 1-2
Accessing the Monitor Program using
the RS 232 MON Connector ..............................................1-2
Accessing the Monitor Program using Telnet .................... 1-3
Operating the Monitor Program .........................................1-4
Configuring Basic Parameters in Access
and Subscriber Units ...............................................................1-5
Configuring Parameters in GU-A-BS Units ............................. 1-6
Introduction ........................................................................1-6
Optimizing the Wireless Link .................................. 2-1
Configuring the Maximum Data Rate (Subscriber Units) ...2-2
Aligning the Antenna of the SU-A/E Subscriber Unit ............ 2-3
Configuring the Transmit Power of the AU-RE ......................2-4
Positioning the SU-I or SU-R Subscriber Unit
with Omni Antennas for Optimal Operation ...........................2-5
Aligning the External Antenna of SU-R and SU-I-D Units .....2-6
BS-GU Connectors ................................................... 3-1
Connecting External Devices to the BS-GU AL IN
and/or AL OUT Connectors ...................................................... 3-2
Alarms In Cable .................................................................3-2
Alarms Out Cable ............................................................... 3-3
GPS Cable ......................................................................... 3-3
SYNC Cable .......................................................................3-5
Verifying Proper Operation ...................................... 4-1
Verifying Connectivity .............................................................. 4-2
Verifying the Ethernet Connection .....................................4-2
Verifying Data Connectivity (Subscriber Unit) .................... 4-2
Verifying Telephone Connectivity
(Subscriber Units with Voice support) ............................... 4-2
Verifying Proper Operation of the GU-A-BS GPS Unit ......4-3
LED Indicators ...........................................................................4-4
SU-RA/RE Outdoor Units LEDs ......................................... 4-4
AU-RA/RE Outdoor Units LEDs ......................................... 4-4
SU-NI and AU-NI Indoor Units LEDs .................................4-5