User's Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE
- About This Manual
- Contents
- Figures
- Tables
- Products Description
- Installation
- Commissioning
- Operation
- 4.1 Introduction to SU Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Troubleshooting
- Glossary
Chapter 4 - Operation ATPC Parameters
BreezeMAX PRO 5000 CPE 70 Product Manual
4.9 ATPC Parameters
In regular operation, the level of the signal transmitted by the SU is controlled by
the Adaptive Transmission Power Control (ATPC) mechanism of the serving BS.
The ATPC page enable temporary control of the signal transmitted by the SU. It is
intended for test purposes only.
These settings will not be saved and will automatically return to original values as
received from the BS when the unit resets or upon closing the web interface.
The ATPC menu includes the following sub-menus:
Show
ATPC
4.9.1 Show
Select this option to view the current Multirate and ATPC parameters:
Last Tx Rate: the last detected transmission rate
Optimal Rx Rate: the transmission rate best suited to the connection
ATPC: The current status (Enabled/Disabled) of the ATPC mechanism
Tx Power: the transmission power level
Figure 4-14: ATPC Show Page