User's Manual

Chapter 2 - Installation Installing the IDU-1D Indoor Unit of the PRO 5000 CPE
BreezeMAX PRO 5000 CPE 26 Product Manual
* After power-up, the WIRELESS LED illuminates until self-test is finished.
2.2.4 RESET Button
The recessed RESET button is located on the front panel of the unit. When
pressed, power to the ODU is disconnected (hard reset).
2.2.5 IDU Installation
1 It is assumed that the IDU-ODU cable is already connected to the ODU.
Assemble an RJ-45 connector with a protective cover on the indoor end of the
IDU-ODU cable. Refer to Section 2.1.6.2 for instructions on preparing the
cable.
2 Connect the IDU-ODU cable to the RADIO connector. The RADIO connector in
the CPE-IDU-1D is located on the front panel as shown in Figure 2-7.
POWER
(on the bottom panel)
3-pin AC Mains power connection
Table 2-5: CPE-IDU-1D LEDs
Name Description Functionality
POWER (3) Power Indication
 Off - IDU is not powered or power failed
 Green - IDU power is OK
ETH (2) Ethernet link status
(Ethernet integrity)
 Off - No Ethernet connectivity has been detected between
the outdoor unit and the device connected to the indoor
unit’s data port
 Green - Ethernet connectivity has been detected between
the outdoor unit and the device connected to the indoor
unit’s data port
WIRELESS (1) Wireless link status
 Off - SU is not associated with a BS
 Green - SU is connected with a BS (network entry
completed)
 Blinking Green - Authentication failed
To install the IDU:
Table 2-4: CPE-IDU-1D Connectors
Name Connector Functionality