User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
68 Extreme CPE Product Manual
Chapter 5 - Unit Control
5.8 Ethernet Operation Mode
The Ethernet Op Mode page enables configuration of the Ethernet connection.
Figure 5-18: Unit Control - Ethernet Op Mode
CURRENT PARAMETERS AND STATUS – Specifies the current Ethernet port
settings.
Auto Negotiation – Describes the auto negotiation status of the Ethernet port.
Speed & Duplex – Describes the speed and duplex capabilities set for the
Ethernet port.
Configured Parameters –
Auto Negotiation – Select to enable or disable auto-negoatiation on the
Ethernet port.
Speed & Duplex – If auto-negotiation is disabled, select from the drop down
menu the speed and duplex setting for the Ethernet port.
Apply – Click ‘Apply’ to save and apply settings to the port.