User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
64 Extreme CPE Product Manual
Chapter 5 - Unit Control
TFTP Server IP Address – Allows the user to enter the IP address of the TFTP
server from which to download code to the unit.
SW File Name – Allows the user to enter the file name of the software file to be
downloaded to the unit.
SW Download – Click ‘SW Download’ to download user specified software to
the unit from the TFTP IP address. The image downloaded will overwrite the
current shadow image.
Reset and Run from Shadow – Click ‘Reset and Run from Shadow’ to reboot
the unit and run from the shadow image.
Set Running Version as Main – Click ‘Set Running Version as Main’ to make
the currently running software configuration the main image.
Refresh – Click ‘Refresh’ to reload the current page and parameters associated
with it.