User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
Reset
Extreme CPE Product Manual 61
5.3 Reset
The Reset page allows you to reset the Extreme CPE for configuration changes to
take effect.
Figure 5-13: Unit Control - Reset Unit
RESET UNIT – Reseting the unit reboots the device.
Reset Unit – Click ‘Reset Unit’ to reboot the Extreme CPE.
NOTE
Reseting the unit does not restore factory defaults.