User Manual

58 Extreme CPE Product Manual
Chapter 5 - Unit Control
 Serial Number – Describes the serial number of the Extreme CPE unit. This
number can be used to determine the identity of the subscriber unit by the
base station operator.
 MAC Address – Describes the physical layer address of the LAN port. The WAN
port MAC address can be determined by adding “1” to the LAN port MAC
address.
 MAC Address Control Number – Displays the MAC address control number.
 Radio Band – Describes the radio band in use. The radio band for the Extreme
CPE is 5.x.
 Hardware version – Describes the revision of hardware in use.
 Hardware configuration – Describes the identity of the current hardware
configuration by serial number.
 RF version – Describes the radio frequency (RF) or rate of oscillation of the
electrical circuit.
 SU Interface Type – Describes the number of ports available on the interface.
“D” refers to data ports, “V” refers to VoIP ports, with a prefix number in use as
a quantifier.
 Radio Type – Describes the receive (Rx) and transmit (Tx) capacity of the
radio.
 Antenna Type – Describes the antenna type employed by the Extreme CPE.
 Ethernet Port Auto Negotiation – Describes the Ethernet port auto
negotiation enable/disable state.
 Ethernet Port Speed & Duplex – Describes the speed and duplex capabilities
to which the Ethernet port has been set to.
 Operation Mode – Describes the operation mode of the Extreme CPE, either
IPCS or ETHCS where IPCS refers to transparent delivery of IPv4 packets and
ETHCS refers to transparent delivery of tagged 802.3 packets over Ethernet.
 Unit Status – Describes the connectivity status of the Extreme CPE to the
base station.