User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
System Status
Extreme CPE Product Manual 53
BEST BSID – The Show All - Best BSID page displays information on the base
station identity (BSID), as well as signal strength indication, noise ratio and
bandwidth of the WiMAX connection.
Configured Best BS ID – Describes the configured base station identity, in the
form xx.xx.xx.xx.xx.xx.
Current Best BS ID – Describes the identity of the best base station, in the
form xx.xx.xx.xx.xx.xx.
Current Best BS RSSI (dBm) – Describes the receive signal strength indicator
of the WiMAX link, in decibels per milliwatt.
Current Best BS SNR (dB) – Describes the signal to noise ratio of the WiMAX
link, in decibels.
Current Bandwidth – Describes the bandwidth of the WiMAX link.
Figure 4-7: Show All - Radio Parameters
RADIO PARAMETERS – The Show All - Radio Parameters page displays
information on the bandwidth and antenna selection of the Extreme CPE.
Configured Bandwidth – Describes the configured bandwidth in megahertz.
Configured Tx Antenna Selection – Describes the configured tranmission
antenna selection.
Configured Rx Antenna Selection – Describes the configured receive
antenna selection.
Configured Rx Attenuator Parameters – Describes the configured receive
signal after attenuation.
Current Bandwidth – Describes the current bandwidth of the WiMAX link.