User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
48 Extreme CPE Product Manual
Chapter 4 - System Settings
4.1 Introduction
The Extreme CPE’s System menu allows you to perform general management
functions for the unit, including setting the system time, configuring an access
password, and upgrading the system software.
Through an easy to use web management interface the Extreme CPE can be
configured to be a powerful wireless connection to any telecommunications
network.
Figure 4-3: Show Settings Menu
NOTE
You can use the web browser interface to access IP addressing only if the Extreme CPE already has
an IP address that is reachable through your network.
The default IP address of the Extreme CPE is 192.168.254.251. You should set your PC network card
to be on the same subnet, with a network mask of 255.255.255.0 and an IP address of
192.168.254.250. This can be set through the Network Connections menu on your PC.