User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
ODU Installation
Extreme CPE Product Manual 25
1 Attach the two threaded bolts to the back of the ODU using a flat screwdriver.
Make sure you use the correct threaded holes for the required polarization.
2 Place the ODU against one side of the pole and then fit the bracket onto the
threaded bolts. The bracket’s V-shaped edges should be against the pole.
NOTE
Antennas in a wireless link must be mounted in the same polarization direction.
NOTE
Make sure that the ODU connectors always face downward.
Attach the two
threaded bolts to the
ODU using a flat
screwdriver
Di
rec
ti
ona
l
A
rrow
Vertical Positioning
Horizontal Positioning
Directional Arrow