User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
ODU Hardware Description
Extreme CPE Product Manual 15
2.2.5 Ground Screw
The ODU includes its own built-in lightning protection, it is important that the
unit is properly connected to ground. A grounding screw is provided for attaching
a ground wire to the unit.
Be sure to use #14 AWG category cable to ground the unit.
The unit can be grounded to the bracket or to the pole, alternatively you can
ground the unit straight to earth.
If grounding to the bracket or the pole make sure that you attach the
grounding wire to a non-painted exposed part of either. Subsequently make
sure that the pole is grounded to earth.
To ground the unit please follow the guidelines below: