User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
ODU Hardware Description
Extreme CPE Product Manual 13
2.2 ODU Hardware Description
2.2.1 Built-in WiMAX Antenna
One high-gain internal antenna is built into the ODU for WiMAX communications.
The antenna must be aligned towards the direction of the WiMAX service
provider’s base station.
2.2.2 Propriety Ethernet RJ-45 Port
The ODU has one propriety 10 PIN RJ-45 PoE port that connects to the IDU using
Ethernet cable. The Ethernet port connection provides power to the ODU as well
as a data link to the IDU.
2.2.3 SAU Port
A Subscriber Unit Alignment Unit (SAU) port is included for connecting an
optional SAU device that provides indicator status LEDs for antenna alignment.
CAUTION
Do not connect a standard RJ-45 Category 5e cable to the ODU port or your unit will not function
correctly. Use only the provided propriety 10 PIN Ethernet cable with 10 PIN plug adapters.
Built-in Antenna
Ground
Screw
SAU Port
Ethernet RJ-45
Port
Eyelet