User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
Extreme CPE Product Manual 119
Table A-1: Troubleshooting Chart
Ports Description
POWER LED is Off AC power adapter may be disconnected. Check
connections between the unit, the AC power adapter, and
the wall outlet.
The unit has detected a system error. Reboot the unit to try
and clear the condition.
If the condition does not clear, contact your local dealer for
assistance.
ETH link LED is Off Verify that the unit and attached device are powered on.
Be sure the cable is plugged into both the unit and
corresponding device.
Verify that the proper cable type is used and its length
does not exceed specified limits.
Check the cable connections for possible defects. Replace
the defective cable if necessary.