User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
98 Extreme CPE Product Manual
Chapter 10 - Performance Monitor
Rx LAN Port Total Packets – Displays the total received packets of the
Ethernet LAN port. The figure will refresh every two seconds.
Tx LAN Port Total Bytes – Displays the transmitted byte rate of the Ethernet
LAN port. The figure will refresh every two seconds.
Tx LAN Port Total Packets – Displays the total number of packets
transmitted by the Ethernet LAN port. The figure will refresh every two
seconds.
Rx WAN Port Bit Rate – Displays the received bit rate of the WiMAX WAN
port. The figure will refresh every two seconds.
Rx WAN Packet Rate – Displays the received packet rate of the WiMAX WAN
port. The figure will refresh every two seconds.
Tx WAN Port Bit Rate – Displays the transmitted bit rate of the WiMAX WAN
port. The figure will refresh every two seconds.
Tx WAN Packet Rate – Displays the transmitted packet rate of the WiMAX
WAN port. The figure will refresh every two seconds.
Rx WAN Port Total Bytes – Displays the total bytes received on the WiMAX
WAN port. The figure will refresh every two seconds.
Rx WAN Port Total Packets – Displays the total packets received on the
WiMAX WAN port. The figure will refresh every two seconds.
Tx WAN Port Total Bytes – Displays the total bytes transmitted by the
WiMAX WAN port. The figure will refresh every two seconds.
Tx WAN Port Total Packets – Displays the total number of packets
transmitted by the WiMAX WAN port. The figure will refresh every two
seconds.