User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
96 Extreme CPE Product Manual
Chapter 10 - Performance Monitor
Maximum Rx Rate – Displays the upper maximum of the received signal
strength detected over a duration of two seconds. The figure will refresh every
two seconds.
Minimum Rx Rate – Displays the lowest received signal strength detected
over a duration of two seconds. The figure will refresh every two seconds.
UL SNR (dB) – Displays the median uplink (UL) Signal-to-Noise Ratio received
by the base station, measured over a duration of two seconds. The figure will
refresh every two seconds.
UL RSSI (dBm) – Displays the median uplink Receive Signal Strength
Indicator received by the base station, measured over a duration of two
seconds. The figure will refresh every two seconds.
Median Tx Rate – Displays the median transmit data rate of the Extreme CPE
in Megabits per second, measured over a duration of two seconds. The figure
will refresh every two seconds.
Last Tx Rate – Displays the most recent transmit data rate of the Extreme
CPE in Megabits per second, measured over the last two seconds. The figure
will refresh every two seconds.
Maximum Rx Rate – Displays the maximum receive data rate of the Extreme
CPE in Megabits per second, measured over a duration of two seconds. The
figure will refresh every two seconds.
Minimum Rx Rate – Displays the mimimum receive data rate of the Extreme
CPE in Megabits per second, measured over a duration of two seconds. The
figure will refresh every two seconds.