User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
82 Extreme CPE Product Manual
Chapter 8 - Radio Parameters
8.3 Frequency Scanning
Frequency Scanning allows the user to enter frequencies with which to scan for
nearby base stations.
Figure 8-29: Radio - Frequency Scanning Parameters
FREQUENCY SCANNING PARAMETERS – The Frequency Scanning Parameters
page specifies the frequency, scanning steps and bandwidth for purposes of
scanning for nearby base stations.
Start Rx Frequency(MHz) – Specifies the frequency at which to start
scanning, in megahertz.
End Rx Frequency(MHz) – Specifies the frequency at which to stop scanning,
in megahertz.
Scanning Main Step(KHz) – Specifies the main step in the frequency
scanning process using the formula F(N) = Start Frequency + N*Main Step, for
N = 0,1,2..
Scanning Intermediate Steps(KHz) – Specifies the intermediate step in the
scanning process using the formula F(N) = Start Frequency + N*(Main Step),
Start Frequency + N*(Main Step + Intermediate Step), for N= 0,1, 2,..
Bandwidth(MHz) – Specifies the bandwidth for the scanning process.