User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
Radio Parameters
Extreme CPE Product Manual 81
8.2 Radio Parameters
The Show Radio Parameters page displays the parameters of the radio settings.
Figure 8-28: Show All - Radio Parameters
RADIO PARAMETERS – The Show All - Radio Parameters page displays
information on the bandwidth and antenna selection of the Extreme CPE.
Configured Bandwidth – Describes the configured bandwidth in megahertz.
Configured Tx Antenna Selection – Describes the configured tranmission
antenna selection.
Configured Rx Antenna Selection – Describes the configured receive
antenna selection.
Configured Rx Attenuator Parameters – Describes the configured receive
signal after attenuation.
Current Bandwidth – Describes the current bandwidth of the WiMAX link.
Current Tx Antenna Selection – Describes the current transmission antenna
selection.
Current Rx Antenna Selection – Describes the current receive antenna
selection.
Current Rx Attentuator Parameters – Describes the current receive
attenuator parameters.