User Manual
Table Of Contents
- About This Manual
- Contents
- Chapter 1 - Product Description
- Chapter 2 - Hardware Installation
- Chapter 3 - Initial Configuration
- Chapter 4 - System Settings
- Chapter 5 - Unit Control
- Chapter 6 - Registration
- Chapter 7 - Base Station Scanning
- Chapter 8 - Radio Parameters
- Chapter 9 - ATPC
- Chapter 10 - Performance Monitor
- Chapter 11 - Service
- Chapter 12 - Management
- Chapter 13 - Logout
- Appendix A - Troubleshooting
- Appendix B - GNU License
- Glossary
BS Scanning
Extreme CPE Product Manual 77
Bandwidth – Describes the optimal bandwidth of the WiMAX link.
Figure 7-26: BST/AU - BST/AU and Preferred BST/AU Parameters
BEST BST/AU TABLE – The BST/AU and Preferred BST/AU Parameters page
describes the user configured base station identity, mask, perferred base station
identity and mask, as well as the mobility mode.
BST/AU ID – Allows the user to configure the base station identity.
BEST/AU ID MASK – Alllows the user to configure the base station mask.
Preferred BST/AU ID – Allows the user to configure the preferred base station
identity.
Preferred BST/AU ID Mask – Allows the user to configure the preferred base
station mask.
Mobility Mode – Selects the mobility mode of the WiMAX radio. (Options:
nomadic and mobile)
Apply – Applies the specified changes.