User's Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to CPE Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 4 - Operation BST/AU Parameters
BreezeMAX PRO 5000 CPE 66 Product Manual
» Rx Frequency (KHz)
» SNR (dB)
» RSSI (dBm)
» Bandwidth
BST/AU and Preferred BST/AU Parameters
» BST/AU ID
» BST/AU ID Mask
» Preferred BST/AU ID
» Preferred BST/AU ID Mask
» Mobility Mode: enables defining the expected mobility of the CPE: Nomadic
or Mobile.
The default is Nomadic.
After configuring the parameters, click Apply to save your changes.
Preferred BS Loss - Timeout before trying to connect to a preferred BS. This
value should vary between 30 minutes and 6 hours increasing dynamically by
30 minutes every time the timer expires, until reaching 6 hours.
» Min. Re-scan Timeout (min): (default 30)
» Max. Re-scan Timeout (min): (default 360)
After configuring the parameters, click Apply to save your changes.