User's Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to CPE Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 4 - Operation Registration Parameters
BreezeMAX PRO 5000 CPE 60 Product Manual
» Rejected: the CPE’s authentication request was rejected.
» Authenticated: the CPE is connected to the BTS.
» Not Operational: no BTS is found.
Click Refresh to update the information.
4.6.2 User Registration
The Registration page enables to set the following parameters. After setting the
parameters, click Apply. The changes are saved, and the Registration - Show page
is displayed. A message that informs about rebooting the unit is also, so that the
changes made will take effect.
User Name: consists of 1 to 32 printable characters, case sensitive.
The default User Name is<CPEMACaddress>@WiMax.com, where
<CPEMACaddress> is the actual MAC of the unit. This is a mandatory
parameter; the User Name must be defined during the installation process for
proper authentication and service provisioning.
The new user name is applied only after rebooting the unit.
Password: the user password (for registration) consists of 1 up to 32 printable
characters, case sensitive. The default password is “quickynikynyoky”.
Figure 4-9: User Registration Page