User's Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to CPE Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 4 - Operation Unit Control Parameters
BreezeMAX PRO 5000 CPE 57 Product Manual
License Files: list of the valid license files that are loaded to the unit
License Parameters: the Bandwidth accepted for the unit. In case of
UNLIMITED the value is 0.
The license files can also be uploaded using the TR069 option. The license can be
downloaded to the CPE just by using the SW Upgrade procedure, only that the file
pointed at is a *.lic file. Refer to “SW Versions Control” on page 51.
4.5.7 Ethernet Operation (Op) Mode
The Ethernet Port control parameter enables viewing and defining the operation
mode of the Ethernet port.
The Ethernet Operation Mode page includes the following fields. The read-only
fields display the current configured parameters. The configurable fields enable to
set a different value for these parameters.
Auto Negotiation: enable/disable Auto Negotiation.
The default is Enable.
Speed and Duplex: If Auto Negotiation is set to Enable, this field is greyed out.
If set to Disable, this parameters allows selecting one of the following options:
» 10Mbps Half-Duplex
» 10Mbps Full-Duplex
» 100Mbps Half-Duplex
Figure 4-7: Ethernet Operation Mode Page