User's Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to CPE Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 4 - Operation Unit Control Parameters
BreezeMAX PRO 5000 CPE 48 Product Manual
» RF Version: The version of the radio module.
» CPE Interface Type: 1D (one data port)
» Radio Type: the receive (Rx) and transmit (Tx) capacity of the radio. 1R/1T
- one receive (Rx) and one transmit (Tx).
» Antenna Type: Dual slant antenna (embedded)
Ethernet Port Operation Mode parameters and status:
» Ethernet Port Auto Negotiation Mode: Enable/Disable
» Ethernet Port Speed and Duplex
» Ethernet Down Timeout: Duration (in seconds) after which the system is
up again.
Operation Mode:
» IP CS - transparent delivery of IPv4 packets
» ETH CS transparent delivery of tagged 802.3 packets over Ethernet
Unit Status: the connectivity status of the unit. Possible statuses are:
» Searching for Base Station
» Base station found
» Not Authorized
» Not Registered
» Registered
SW Versions:
» SW Boot Version
» Main SW File Name
» Main SW Version
» Shadow SW File Name