User's Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to CPE Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 3 - Commissioning Configuring Basic Parameters
BreezeMAX PRO 5000 CPE 32 Product Manual
3.2 Configuring Basic Parameters
3.2.1 The Basic Parameters
Table 3-1: CPE Basic Parameters
Parameter Default Value Comment
Country Code Must be set in accordance to
designated country and deployment
scenario
Ethernet Port auto Negotiation
Enable/Disable
Enabled
Ethernet Port Speed and Duplex Applicable only if Ethernet Auto
Negotiation Enable/Disable is set to
Disable
User Name CPEMACaddress@WiMax.com Should be supplied by system
administrator/operator
User Password Empty Should be supplied by system
administrator/operator
Organization Empty
Address Empty
Country Empty
BST/AU ID 0.0.0.0.0.0
BST/AU ID Mask 0.0.0.0.0.0
Preferred BST/AU ID 0.0.0.0.0.0
Preferred BST/AU ID Mask 0.0.0.0.0.0
Bandwidth Auto (5/10 MHz)
Start Rx Frequency (KHz) Depends on Radio Band and
Bandwidth
End Rx Frequency (KHz) Depends on Radio Band and
Bandwidth
Scanning Main Step 2.5 MHz
Discrete Scanning Frequencies Null (empty list)