User's Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to CPE Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 2 - Installation Installing the ODU of the CPE
BreezeMAX PRO 5000 CPE 16 Product Manual
NOTE
There is a groove on one end of the threaded rod. Insert the rods with the grooves pointing
outward, and fasten them to the unit using a screwdriver. Install the unit with the bottom panel,
which includes the connectors, facing downward.
You can install the ODU with the arrow on the back of the unit facing upwards or rightwards.
Match the polarity of the transmission antenna to the polarity of the receiver antenna.
Make sure that the connectors are facing downwards.
Figure 2-1: ODU Pole Installation Using the Special Clamp, Arrow Facing Upwards
Grounding
screw