User's Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to CPE Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 4 - Operation Management Parameters
BreezeMAX PRO 5000 CPE 83 Product Manual
eCPE Manager IP Address (acquired from a DHCP server, or Not Available)
eCPE Manager Connection Status (Up, Down or Not Connected)
4.12.2 DHCP Client Configuration
The DHCP Client Configuration page enables viewing and updating the
parameters of the DHCP client.
Dhcp Client
Client IP Address
Network Mask
Default Gateway IP Address
TR069 Server IP Address
By default, DHCP Client is enabled (IP address allocated by DHCP), therefore
parameters cannot be modified.
To change the parameters in order to have static IP address for the CPE
management, select the Disable option, modify the values and click Apply.
Figure 4-21: Dhcp Client Configuration
NOTE
The DHCP Client can be set to disable only in ETH-CS service