User Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to SU Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 4 - Operation Performance Monitor
BreezeMAX PRO 5000 CPE 77 Product Manual
The Ethernet On-Line Counters table displays a continuously updated list of the
traffic counters. The display is updated every 2 seconds based on counters
collected during this period. The displayed counters include the following for each
port (LAN/WAN) and each direction (TX/RX):
Bit Rate
Packet Rate
Total Bytes
Total Packets
Rate counts are the average rate (Bytes/Packets per second) for the last
measurement interval (2 seconds).
Total counts are the accumulated number of Bytes/Packets since the last unit
reset or the last Counters Reset.
4.10.3 Integration Time
The Integration Time page enables to set the frequency with which the CPE will
monitor traffic statistics on both the WiMAX link and Ethernet link.
The Link Quality Historical table enables to define a time period for monitoring the
WiMAX WAN port link to either 1 or 15 minutes.
The Ethernet Historical table enables to define a time period for monitoring the
Ethernet LAN port link to either 1 or 15 minutes.
To set the time period, select the required option and click Apply.
Figure 4-19: Integration Time Page