User Manual

Chapter 4 - Operation Radio Parameters
BreezeMAX PRO 5000 CPE 69 Product Manual
first selecting the frequency to be deleted and click Delete select. The Delete
select button is available only if at least one discrete frequency is added.
 Delete All Discrete Frequencies: to delete all discrete frequencies, click on
Delete All.
 Discrete Scanning Frequencies: enables to enter discrete frequencies, as
follows:
» Update List of Discrete Frequencies: Enter a list of up to 10 discrete
frequencies in steps of 2.5MHz, separated by commas (no space). This list
will replace the current list of discrete frequencies.
» Add One Discrete Frequency: Enter one frequency to be added to the
current list of discrete frequencies.
 Update Scanning Table: select this option to update the frequency scanning
table in run time (without resetting the unit).
 Clear Best BS Table: select this option to clear the current Best BS Table.
Typically this should be done prior to initiating a full scanning process (see
below).
 Force Full Scanning: select this option to initiate a full scanning process.
4.8.3 Antenna Selection
The Antenna Selection page enables viewing the parameters of the integrated
antenna. The following parameters are displayed:
 Radio Status
 Antenna: enables selection of antenna. Currently only one integrated antenna
is supported, and therefore selection is not available.
Figure 4-13: Antenna Selection Page