User Manual
Table Of Contents
- BreezeMAX PRO 5000 CPE Product Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Product Description
- Chapter 2 - Installation
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 Introduction to SU Management
- 4.2 Accessing the Web Configuration Server
- 4.3 Using the Web Configuration Server
- 4.4 Show All
- 4.5 Unit Control Parameters
- 4.6 Registration Parameters
- 4.7 BST/AU Parameters
- 4.8 Radio Parameters
- 4.9 ATPC Parameters
- 4.10 Performance Monitor
- 4.11 Service Parameters
- 4.12 Management Parameters
- 4.13 Logout
- 4.14 Parameters Summary
- Appendix A - Troubleshooting
- Glossary
Chapter 4 - Operation Unit Control Parameters
BreezeMAX PRO 5000 CPE 48 Product Manual
» Shadow SW File Name
» Shadow SW Version
» Running from: Main or Shadow
Upload/Download Parameters:
» Local TFTP Server IP address: the IP address of the TFTP server from the
LAN side used for SW File/Configuration File download.
» Remote TFTP Server IP address: the IP address of the TFTP server from the
WAN side used for SW File/Configuration File download.
» SW File Name: the name in the TFTP server of the SW version to be
downloaded to the unit.
» Configuration File Upload Name: the name of the configuration file to be
uploaded.
» Configuration File Download Name: the name of the configuration file to be
downloaded.
4.5.2 Reset Unit
The Reset Unit page enables to reset the unit. Click Reset Unit. To avoid
unintentional reset, you will be prompted to confirm the reset request. Changes to
most of the configurable parameters are applied only after reset. Refer to
Section 4.14 for information on which parameters are changeable in run time and
which changes are applied only after reset.
Figure 4-2: Reset Unit Page