User's Manual

Chapter 2 - Installation BTS Installation
BreezeMAX Extreme 34 System Manual
1 Assemble the tilt bracket on the BTS and fasten its four screws (see
“Assembling the Tilt Bracket on the BTS” on page 29).
2 Thread the four metal bands through the grooves on the BTS carriage and
fasten them (see Figure 2-7).
3 Attach the carriage to the pole and fasten the metal bands (see Figure 2-7).
4 Insert the Tilt Control screws into the middle-side hole of the carriage on both
sides (Figure 2-7).
2.1.5 Mounting the BTS on the Carriage
At this stage, after mounting the BTS on the carriage, use the Tilt bracket to tilt
and rotate the BTS as required.
1 Hang the BTS with the tilt bracket on the Tilt-control screws of the BTS
carriage.
2 Attach and fasten all the screws at both sides of the BTS carriage . Do not over
tighten.
To install the Carriage on a pole larger than 6'':
Figure 2-7: Installed Carriage with Metal Bands
To mount the BTS on the carriage:
Tilt control screws
Metal bands