User's Manual

Chapter 2 - Installation BTS Installation
BreezeMAX Extreme 31 System Manual
2.1.3 Installing a Lightening Arrestor for the
High-Gain GPS Antenna
If you use a High-Gain GPS antenna with a cable longer than 3m, a lightening
arrestor must be installed near the BTS.
2 Install the lightening arrestor (part of the GPS Kit, see “GPS Installation” on
page 38) at the designated location at the bottom of the carriage (see
Figure 2-3).
3 Connect one end of the 0.5 m cable to the lightening arrestor and the other
end to the GPS ANT connector on the BTS.
2.1.4 Installing the BTS on a Pole
The BTS can be installed on poles of various sizes, using the supplied carriage
(see Figure 2-4). For poles of 2''-6'' in diameter, use the supplied metal clamps.
For poles larger than 6'' use metal bands.
Figure 2-3: Installing the Lightening Arrestor on the Carriage
NOTE
Some units are supplied with a separate pole-mounting bracket for the lightning arrestor. Instead of
attaching the lightening arrestor to the carriage, install this bracket on the pole as close to the BTS
as possible, allowing connecting the lightning arrestor to the BTS’s GPS connector.
Lightening Arrestor
Carriage
Hole for lightening
arrestor