Quick Installation Guide

Table Of Contents
BreezeMAX Extreme Base Transceiver Station Quick Installation Guide
P/N 215790
- 8 - January 2011
Name Description Functionality
ETH Ethernet link status
Off - No Ethernet connection
Green - Lights when the backhaul Ethernet is connected and
blinks 500ms on and 500ms off when data traffic appears on the
Ethernet link.
WLNK Wireless link status
Off - No wireless link (no MS is registered)
Green - Blinking when the wireless link is working (transmitting),
indicating that there is at least one registered MS being served
by the unit.
GPS GPS synchronization status
Off - GPS is not synchronized (see below) or not installed.
Green - On once the GPS is reporting on reception of at least 4
satellites (initial synchronization).
Blinking Green - (0.5 Sec on, 0.5 Sec off) the number of received
satellites decreased from 4 (or more) to 3 or 2 satellites.
1PPS 1PPS clock status Master Unit
Off - GPS is not installed.
Green - 1PPS clock is supplied by GPS.
Slave Unit:
Off - External 1PPS is not supplied.
Blinking Green - blinking at the 1PPS rate when external 1PPS
clock is supplied.
* All LEDs are turned on upon power up and turn off after successful completion of the built-in-test.
FCC Radio Frequency Interference Statement
The Base Transceiver Station (BTS) equipment has been tested and found to comply with the limits for a class A digital device,
pursuant to ETSI EN 301 489-1 rules and Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in commercial, business and industrial environments. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to correct the interference at the user's own
expense.
FCC Radiation Hazard Warning
To comply with FCC RF exposure requirements in Section 1.1307 and 2.1091 of FCC Rules, the antenna used for this
transmitter must be fixed-mounted on outdoor permanent structures with a separation distance of at least 2 meter from all
persons.
R&TTE Compliance Statement
This equipment complies with the appropriate essential requirements of Article 3 of the R&TTE Directive 1999/5/EC.
Disposal of Electronic and Electrical Waste
Disposal of Electronic and Electrical Waste
Pursuant to the WEEE EU Directive electronic and electrical waste must not be disposed of with
unsorted waste. Please contact your local recycling authority for disposal of this product.