Quick Installation Guide
Table Of Contents
- Packing List
- Additional Installation Requirements
- Equipment Positioning Guidelines
- Installation Guidelines
- Installing the BTS
- Installing the GPS
- Indoor Power Supply Installation
- Connecting the Cables to the BTS
- Configuring BTS Basic Parameters
- Operation Verification
- FCC Radio Frequency Interference Statement
- The Base Transceiver Station (BTS) equipment has been tested and found to comply with the limits for a class A digital device, pursuant to ETSI EN 301 489-1 rules and Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in commercial, business and industrial environments. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at the user's own expense.
- FCC Radiation Hazard Warning
- To comply with FCC RF exposure requirements in Section 1.1307 and 2.1091 of FCC Rules, the antenna used for this transmitter must be fixed-mounted on outdoor permanent structures with a separation distance of at least 2 meter from all persons.
- R&TTE Compliance Statement
- Disposal of Electronic and Electrical Waste
BreezeMAX Extreme Base Transceiver Station Quick Installation Guide
P/N 215790
- 4 - January 2011
Figure 4: Assembling the Carriage on 1.5”-4” Poles Using Clamps
Figure 5: Assembling the Carriage on Poles Larger than 4” Using Metal Bands
Nuts,
washers
and spring
washers
Clamps
Rods
Holes for wall mount (x4)
Tilt control screw
Metal bands
Tilt control screw
5. Insert the Tilt Control screws into the middle-side hole of the carriage on both sides.
6. Hang the BTS with the tilt bracket on the Tilt-control screws of the BTS carriage.
7. Attach and fasten all the screws at both sides of the BTS carriage. Do not over tighten.
8. If required, slightly release the tilt bracket screws to enable rotation and the Tilt Control screws to enable tilting; adjust the
BTS position and tighten the screws. Apply torques of 45 [Lib*In.] = 5 [N*m] to the M6 Tilt-control screws, and
80 [Lib*In] = 9 [N*m] to the M8 screws.
Figure 6: BTS Mounted on a 1.5''-4'' Pole (with Clamps), and on Pole Larger than 4” (with Metal Bands)