Quick Installation Guide
Table Of Contents
- Packing List
- Additional Installation Requirements
- Equipment Positioning Guidelines
- Installation Guidelines
- Installing the BTS
- Installing the GPS
- Indoor Power Supply Installation
- Connecting the Cables to the BTS
- Configuring BTS Basic Parameters
- Operation Verification
- FCC Radio Frequency Interference Statement
- The Base Transceiver Station (BTS) equipment has been tested and found to comply with the limits for a class A digital device, pursuant to ETSI EN 301 489-1 rules and Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in commercial, business and industrial environments. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at the user's own expense.
- FCC Radiation Hazard Warning
- To comply with FCC RF exposure requirements in Section 1.1307 and 2.1091 of FCC Rules, the antenna used for this transmitter must be fixed-mounted on outdoor permanent structures with a separation distance of at least 2 meter from all persons.
- R&TTE Compliance Statement
- Disposal of Electronic and Electrical Waste
BreezeMAX Extreme Base Transceiver Station Quick Installation Guide
P/N 215790
- 3 - January 2011
Installing the BTS
1. Assemble the tilt bracket on the BTS and fasten its M8 screws. Apply torque of 80 [Lib*In] = 9 [N*m]
Figure 2: Assembling the Tilt Bracket on the BTS
Carrying grooves
BTS
Tilt bracket
M8X20 screws
2. Install a lightning arrestor (part of the GPS kit) at the designated location at the bottom of the carriage.
3. Connect one end of the 0.5m cable to the lightning arrestor and the other end to the GPS ANT connector on the BTS.
NOTE:
Some units are supplied with a separate pole-mounting bracket for the lightning arrestor. Instead of attaching
the lightning arrestor to the carriage, install this bracket on the pole as close to the BTS as possible, allowing
connecting the lightning arrestor to the GPS connector on the BTS.
The lightning arrestors supplied within the GPS kit are not included in the warranty cover provided for the GPS
unit. Additional lightning arrestors can be ordered separately.
Figure 3: Assembling the Lightning Arrestor on the Carriage
Carriage
Lightning arrestor
Hole for lightning arrestor
4. Do one of the following:
For poles up to 4” - Thread the four rods through the carriage. Insert the threaded rods with the grooves
pointing outward, as these grooves enable you to use a screwdriver to fasten the rods to the unit. Attach the
carriage and the clamps to the pole and tighten on both sides using the supplied washers, spring washers
and nuts. Apply torque of 80 [Lib*In] = 9 [N*m].
For poles larger than 4” - Thread the four metal bands through the grooves on the carriage and fasten.
For wall mount installation - mark the exact location of the holes to drill on the wall. Drill the holes, and use
four metal dowels and screws to affix the carriage to the wall.