Installation Manual

Chapter 2 - Installation Installing GPS
BreezeMAX Extreme 58 System Manual
2.4 Installing GPS
The GPS is connected to the GPS/SYNC IN connector. Before connecting the
cable, make sure that the length of the cable is sufficient to reach the BTS.
Mounting Kit:
1 Place the bracket on a flat surface and thread the supplied pipethrough the
bracket hole and into the GPS antenna. Hand-tighten until snug. Do not
over-tighten or use a tool. Make sure that the connector (male) is on the open
side of the bracket.
2 Connect the interface cable to the antenna. hand-tighten the connector on the
interface connector using the locking ring for securing the connection. Do not
over-tighten to avoid stripping the connector.
3 Use the supplied clamps to assemble the GPS and bracket on a pole. Use the
M8 nuts, washers, and spring washers to lock the clamps to the bracket.
Apply torque 9 [N*m] (80 [lbs*in]).
Table 2-2: GPS Mounting Kits
Item Description
GPS Antenna kit- Normal
 Antenna
 3m cable
 Pole mount bracket
 Mounting band
GPS antenna kit - bullet
 Bullet antenna
 25m cable
 Pole mount bracket
 Mounting band
 Lightning protectors
GPS chaning cable Cable to chain GPS signal between 2 colocated Extreme
base stations
To install the GPS: