Installation Manual

Table Of Contents
Chapter 2 - Installation Mounting the BTS
BreezeMAX Extreme 56 System Manual
2.3.3 Installation the BTS on a 4” (or more) Mast
Using the tilt extension, and heavy duty metal bands.
1 Assemble the tilt extension on the BTS and fasten its three screws (see
“Assembling the Tilt Extention on the BTS” on page 52).
2 Thread the metal strips through the BTS carriage (see Figure 2-7).
3 Attach the carriage to the pole and fasten the metal strips (see Figure 2-7).
4 Thread screws through the middle-side holes of the carriage (see Figure 2-7).
5 Hang the BTS with the tilt extension on the middle screw of the tilt bracket.
6 Attach and fasten all the screws at both sides of the tilt bracket (see
Figure 2-8).
7 If required, assemble the external antennas at the top of the rasdio-headby
screwing them in.
Figure 2-7: Installed Carriage - Side View
Screw