User Manual

Chapter 4 - Operation and Administration The Monitor Program
BreezeMAX Extreme 60 System Manual
4.2 The Monitor Program
4.2.1 Accessing the Monitor Program
1 The PC used for accessing the Monitor program should be configured
according to the BTS Management Connectivity parameters (see “Connectivity”
on page 71).
2 Run the Telnet program connecting to the IP address of the connected port.
3 Select the access level according to your access rights.
4 The Enter the password message is displayed. Enter the password and press
the Enter key to get to the Main menu. The default passwords are:
4.2.2 Using the Monitor Program
This section describes the Monitor program structure and navigation rules.
To access the Monitor program using Telnet:
Table 4-1: Default Passwords
Access Level Default Password
Administrator admin
Installer installer
Monitor monitor
NOTE
Following three unsuccessful login attempts (using incorrect passwords), access to the monitor
program will be blocked for 5 minutes.
If you forgot the Installer or Monitor password, the Administrator can login (with the Administrator
password) and define a new password for Installer and/or Monitor access level.
If you forgot the Administrator password, type "help" to receive a challenge string consisting of 24
characters. Contact Alvarion's Customer Service and provide the challenge string (after user
identification) to receive a temporary password. You can use this password only once to enter the
program. The password must be changed during the session to a different "permanent" password.
The system administrator should be notified of this new password. Five consecutive errors in
entering the temporary password will invalidate it. In this case, repeat this procedure to receive a
new challenge string for a new temporary password.