User Manual

Chapter 4 - Operation and Administration ASN-GW Menu
BreezeMAX Extreme 116 System Manual
range values of any Classifiers of the same Type for the same direction
assigned to any of the Service Rules assigned to other Multiple Service
Flows that are assigned to other Services for the same MS.
Each Classifier includes the following components:
4.6.2.7.1 Uplink/Downlink Classifier Type
This parameter defines the type of classifier to be used in the applicable direction.
Different classifier types may be defined for the uplink and downlink directions.
The available options are None, DSCP, VLAN ID and VLAN Priority. If the CS Type
of the Service Interface assigned to the Service Rule is IP CS, then only None and
DSCP types are supported.
For a Classifier Type Any there are no other parameters.
4.6.2.7.2 Uplink/Downlink Classifier Parameter 1 and 2
Each Classifier of any type other than None can define a range of value to be used
for classification. These parameters defines the lowest and highest values in the
range. The applicable range values are:
The value configured for Parameter 2 for a certain direction cannot be lower than
the value configured for Parameter 1 for the same direction.
Note that the value configured for any of these parameters cannot be within the
ranges defined for other Classifiers of the same Type and Direction assigned to
Table 4-9: Classifier Parameters
Uplink/Downlink
Classifier Type
Uplink/Downlink
Classifier Parameter 1
Uplink/Downlink
Classifier Parameter 2
Any - -
DSCP Lowest DSCP Value Highest DSCP Value
VLAN ID Lowest VLAN ID Value Highest VLAN ID Value
VLAN Priority Lowest VLAN Priority Value Highest VLAN Priority Value
Table 4-10: Uplink/Downlink Classifier Parameters Range Values
Uplink/Downlink Classifier
Type
Uplink/Downlink Classifier Parameter
1 and 2
DSCP 0-63
VLAN ID 1-4094
VLAN Priority 0-7