User's Manual
Table Of Contents
- BreezeMAX Extreme System Manual
- About This Manual
- Contents
- System Description
- 1.1 About WiMAX
- 1.2 WiMAX Network Architecture
- 1.3 BreezeMAX Extreme
- 1.4 Specifications
- Installation
- 2.1 BTS Installation
- 2.2 GPS Installation
- 2.3 Indoor Power Supply Installation
- 2.4 Cable Connections
- 2.5 External Antennas Connection
- Commissioning
- Operation and Administration
- 4.1 BreezeMAX Extreme System Management
- 4.2 The Monitor Program
- 4.3 IP Addresses Configuration
- 4.4 The Main Menu
- 4.5 BTS Menu
- 4.5.1 Show Summary
- 4.5.2 Show Properties
- 4.5.3 Configuration
- 4.5.4 Unit Control
- 4.5.5 Fault Management
- 4.5.6 Performance Counters
- 4.6 ASN-GW Menu
- 4.7 Sector Menu
- 4.8 BS Menu
- 4.9 Radio Channel Menu
- 4.10 Antenna Menu
- 4.11 GPS Menu
- 4.12 MS Menu
- 4.13 Parameters Summary
- Glossary

Chapter 4 - Operation and Administration Sector Menu
BreezeMAX Extreme 130 System Manual
Configured Startup Test Valid Period (hours)
Current Radar Detection Threshold (dBm)
Current Radar Detection Threshold (dBm)
Rx Antenna Gain (dBi): The value configured for the Antenna associated with
the relevant Sector.
Bandwidth (MHz): The current Bandwidth of the Sector.
Tx Power (dBm): The current Tx Power of the Sector.
Frequencies List: The current list of frequencies configured for the DFS
mechanism
4.7.2.2.2.2 Show Frequencies Status Table
The DFS Frequencies Status table provides status details for each of the relevant
frequencies (see “Usable Frequencies” on page 132). The details provided for each
entry are:
Frequency (MHz).
Detected Time: The last date and time at which the test results indicated a
presence of radar activity on this frequency, or N/A if the frequency was not
tested since last reset. The frequency is considered as Unavailable for selection
by the DFS mechanism if the elapsed time since the Detected Time is not
higher than Channel Non Occupancy Period.
Last Clear Channel Test: The last date and time at which the test results
indicated that there is no radar activity on this frequency, or N/A if the
frequency was not tested since last reset. The frequency is considered as
Available for selection by the DFS mechanism if the elapsed time since the
Last Clear Channel Test is not higher than Startup Test Valid Period.
4.7.2.2.2.3 Update General Parameters
The configurable DFS parameters and options are:
DFS Support
Channel Availability Check Time (sec)