User's Manual

Chapter 4 - Operation and Administration ASN-GW Menu
BreezeMAX Extreme 112 System Manual
 Service Group Name
4.6.2.5.1 Multiple Service Flow ID
This is an auto-sequential number from 1 to a maximum of 1030, generated
automatically during creation of a new Multiple Service Flow.
4.6.2.5.2 Multiple Service Flow Name
The Name of the Multiple Service Flow. A unique string of 1 to 32 characters.
4.6.2.5.3 Service Group Name
The name of the Service Group associated with the Multiple Service Flow. Must be
a name of a previously defined Service Group that exists in the database.
4.6.2.5.4 Service Operation Mode
The Service Operation Mode parameter is applicable only to IP CS services. The
Service Operation Mode parameter defines whether NAT routing is used by the MS
or behind the MS (Router mode) or not (Bridge mode).
In Bridge mode, the ASN-GW learns the IP address assigned to the MS, and
associate with this IP address the VLAN ID defined in the Service Interface
specified in the Service Rule that matches the connection used for DHCP.
In Router mode, the ASN-GW checks all the Router mode Multiple Service Flows
assigned to the same MS that use the same Service Group as the relevant
connection, and associate with the IP address all VLAN IDs defined in relevant
Service Interfaces.
If the MS functions as a NAT router, all its Services will operate in Router mode. If
there is a router behind the MS, the Management Service will operate in Bridge
mode and other Services will operate in Router mode.
4.6.2.6 Service Rules
The Service Rules menu enables managing Service Rules, including the
Classifier(s) associated with each Service Rule. The menu for a selected Service
Rule (after the basic parameters are defined) enables access to the Classifiers
submenu. At least one Classifier must be assigned to each Service Rule, up to a
maximum of five Classifiers per Service Rule. For details refer to Classifiers
(Section 4.6.2.7) below.
When either defining a new Service Rule and its components or updating an
existing one, note that a Multiple Service Flow can include a maximum of one
Service Rule with a Classifier of type Any.
The Service Rule basic parameters are: