User's Manual

Installing Accessories
BreezeNET BU-DS.11/RB-DS.11 6-1 User’s Guide
6. INSTALLING ACCESSORIES
This chapter introduces some of the accessories available for specific installations,
and describes how to install them.
6.1 RFS 122 Radio Frequency Splitter
The RFS 122 Radio Frequency Splitter is used to split the RF signal generated by a
transmitter into two signals. These signals are then sent to two different and
independent antennas. The RFS 122 enables radio transmission using two directional
antennas connected to the same port of the BreezeNET DS.11 unit. Similarly, the
splitter is used to combine two receiving antennas to one antenna connector.
Before installing the RFS 122, configure the BreezeNET DS.11 unit using the DS.11
Management utility to transmit through Antenna 2 only (see Section 3.1.5), and
connect the RFS 122 to antenna connector 2.