User's Manual

The DS.11 Management Utility
BreezeNET BU-DS.11/RB-DS.11 3-15 User’s Guide
Encryption Supported are displayed in the Version box in the General Info tab
shown in Figure 3-5 on page 3-7.
Values: Unknown Card is not inserted.
Implemented Shared Key authentication is enabled.
Not Implemented Shared Key authentication is disabled. Only
open system authentication is available in
this mode.
If you selected the Shared Key algorithm, proceed to set the following parameters:
•1 Default Key ID – Sets the default key for encryption in the Authentication
process. This is the encryption key that will be used for transmissions between
the station and the BU-DS.11.
•2 WEP Key – Define the encryption keys used for transmissions between the
station and the BU-DS.11. Specify each key by clicking the appropriate WEP Key
row (First, Second, Third or Fourth) and entering 10 Hex digits (5 pairs of
characters) for each of the 4 keys.
3.1.11 Debug Info(rmation)
This option allows you to create a log file named BreezeLog.log. You can send this log
file to BreezeCOM technical support and receive help based on the information
recorded in this file.
To start recording, open the Debug Info option and select Start Log.
When you finish recording (usually after 24 hours) select Stop Log and send the file
to BreezeCOM technical support representatives.