User's Manual

Installation
BreezeNET BU-DS.11/RB-DS.11 2-23 User’s Guide
2.8.2 Reloading Factory Default Settings
The Reset button, located on the Indoor unit front panel, is used to restore the factory
default parameter settings of the Outdoor unit (in the event that the default settings
were changed via an SNMP management station).
To reset the unit:
1. Disconnect the power cable from the Indoor unit.
2. Insert a paper clip and press the Reset button while inserting the power cable back
into its socket at the same time.
2.8.3 Connecting the Unit to the Ethernet Port
•1 Connect one end of a an Ethernet 10BaseT cable (not supplied) to the RJ-45 port
on the front panel of the Indoor unit, using a straight cable.
•2 Connect the other end of the connector cable to the Ethernet outlet.