User's Manual

Installation
User's Guide 2-20 BreezeNET BU-DS.11/RB-DS.11
2.8 Installing the Indoor Unit
According to the specific conditions of the installation, route the Indoor-to-Outdoor
cable into the building so that it conveniently reaches the Indoor unit to ensure
minimal interference, leaving some spare. The cable is supplied open ended at the side
of the Indoor unit, to allow for conveniently threading it into the building through a
hole that is as small as possible. Assemble the connector and cover plug supplied with
the cable. Appendix B provides instructions on how to assemble the connector on the
Indoor-to-Outdoor cable.
1. Remove the wall mounting bracket clipped to the rear of the Indoor unit and
mount the Indoor unit on a wall as shown in Figure 2-6.
2. Connect the Indoor-to-Outdoor cable to the Radio connector, located on the front
panel of the Indoor unit shown in Figure 2-8. The Indoor-to-Outdoor cable should
be connected to the unit before it is connected to the mains power.
Figure 2-6. Wall Mounting the Indoor Unit