User's Manual

Installation
User's Guide 2-14 BreezeNET BU-DS.11/RB-DS.11
2.6.15 Rain Proofing
18 and 24 dBi antennas must be sealed against rain at the point the cable enters the
pole before they are suitable for external use.
2.7 Installing the Outdoor Unit
The outdoor unit can be secured to the pole using one of the following options:
•1 Special brackets (supplied with each unit)
•2 U-bolts - size A (inner installation holes, up to 2" pole)
•3 U-bolt - size B (outside installation holes, up to 3" pole)
•4 Metal bands (9/16” wide, minimum 12” long)
Figure 2-2 shows the locations of the holes, grooves and screw holes on the rear side
of the unit.
Figure 2-3 illustrates the method of installing an unit on a pole using the supplied
brackets.
Note: Make sure to install the unit with the bottom panel (the panel with the signal
strength bar and LEDs) facing downward.
Figure 2-2. Holes/Grooves/Screw Holes